Tunneling is when a candle burns straight down the middle and leaves a thick wall of unmelted wax around the edge. It wastes wax, weakens the scent and can drown the wick. The short answer: it almost always starts with a first burn that was too short — and a shallow tunnel can usually be fixed.

Why candles tunnel

A container candle tends to "remember" its first melt pool. If the wax only melted halfway to the glass the first time, later burns keep melting inside that same ring, and the tunnel gets deeper each time. Short burns of 20–30 minutes make it worse.

How to fix a tunneled candle

Shallow tunnel (a few millimetres): next time, simply let it burn longer — until the liquid wax reaches the glass all the way round.

Deeper tunnel — the foil method, widely recommended by candle makers:

  1. Wrap a few layers of aluminium foil around the top of the jar, leaving an opening in the centre over the flame.
  2. Light the candle. The foil reflects heat back to the edges, so the wax walls start to melt.
  3. After 1–2 hours, once the surface is level, remove the foil carefully — it will be hot.

Stay with the candle while the foil is on.

Prevent it: the first burn

The National Candle Association's rule of thumb is about one hour of burning per inch (2.5 cm) of diameter. Our candles are 8 cm wide, so the first burn takes about 3 hours. Watch the result rather than the clock: the melted layer should touch the glass all around. Plan the first burn for an evening at home, not for 20 minutes before you go out.

Every burn after that

  • Trim the wick to about 6 mm (¼ inch) before each burn and remove trimmings or match ends from the wax (NCA). A short wick gives a steadier flame and less soot.
  • Burn for no more than 4 hours at a time (NCA), then let the candle cool before relighting.
  • Stop when about 1 cm (½ inch) of wax is left in the jar, so the glass doesn't overheat.
  • Keep it away from drafts, fans and open windows — they cause flickering, soot and uneven burning.

How to put a candle out

A snuffer is the safest option because it doesn't splatter hot wax. NFPA advises against using water: hot wax can splatter and a glass container may crack.

Safety basics

  • Never leave a burning candle unattended, and put it out when you leave the room or go to sleep.
  • Keep it at least 30 cm (12 inches) from anything that can burn (NFPA).
  • Leave a few centimetres (about 3 inches) between candles (NCA).

More in our guides to candle care and candle safety.

In short

  • Tunneling comes from short first burns; fix it with a long burn or the foil method.
  • First burn: until the wax melts to the edge — about 3 hours for an 8 cm candle.
  • Trim the wick to ~6 mm, burn no more than 4 hours, stop at ~1 cm of wax.
  • Use a snuffer, not water.